How to configure PB Printer to
work through USB Cable ?
HOLD BOTH STATION1 and STATION2
BUTTONS IN THE PRINTER
Switch on the
printer
Leave the
Buttons
Insert the paper into the
printer
Automatically Printer will take
the paper inside and a message will be printed as follows
STATION 1-CONFIRM STATION
2=SKIP PRESS LOCAL TO CONTINUE
Press LOCAL and then STATION
1
The Default Configuration will
be printed as follows
MENU
: CONFIG Press STATION
1
DRAFT SPEED:
NORMAL Press STATION 1
LQ
TYPE: NLQ1 Press STATION
1
PAPER WIDTH:
FIRST LINE Press STATION 1
BUZZER:
Y Press STATION 1
INTERFACE By
default SERIAL or COM1 will be there
Press STATION2
Till USB is printed and then Press
STATION 1
USB EMULATION By
default OLIVETTI will be there Press STATION2
Till IBM is printed and then Press
STATION 1
PLUG&PLAY:
N Press STATION 1
PAP.EDGE DECTEC.:
N Press STATION 1
SPECIAL FORMS:
N Press STATION 1
PRINT MODE
STANDARD Press STATION 1
BIM MODE:
MONO Press STATION 1
PNS SELECTIONS:
N Press STATION 1
SAVE PARAMETERS
Y Press STATION 1
MENU
: CONFIG
Leave the paper in the printer
and switch off the printer (Press power button in the PB
printer)
SWITCH ON THE
PRINTER
Automatically the paper will be
ejected
THE SAME METHOD MAY BE USED TO
CONFIGURE SERIAL OR COM1 PORT
Thanks to
:
P N Satish
Postmaster Grade – I
Byndoor Post Office,
Udupi Division, Karnataka - 576214
No comments:
Post a Comment